American Geophysical Union Become an AGU Member
Subscribe to AGU Journals		 AGU Home AGU Publications

Read Full Article (file size: 1553505 bytes)    Cited by

JOURNAL OF GEOPHYSICAL RESEARCH, VOL. 107, NO. B10, 2259, doi:10.1029/2001JB000173, 2002

A two-dimensional inverse model for extensional sedimentary basins 1. Theory

Nicky White

Department of Earth Sciences, University of Cambridge, Bullard Laboratories, Cambridge, UK


Paul Bellingham

Department of Earth Sciences, University of Cambridge, Bullard Laboratories, Cambridge, UK


Abstract

A simple two-dimensional inverse model for extracting the spatial and temporal variation of strain rate from extensional sedimentary basins is described. Our starting point is a forward model which allows basin stratigraphy to be calculated from any given strain rate distribution. This forward model includes potentially important effects such as flexural rigidity and the two-dimensional conduction/advection of heat. Conversely, inverse modeling determines strain rate variation by minimizing the misfit between predicted and observed patterns of basin subsidence. No a priori assumptions about the number, duration, or intensity of rifting episodes are necessary. Instead, strain rate is allowed to vary smoothly throughout time and space. An important restriction is that vertical lines remain vertical, but this restriction can be relaxed if deemed necessary. We have successfully inverted different synthetic sedimentary basin geometries which were generated by forward modeling. Sensitivity analysis and noise tests demonstrate that strain rate patterns can be recovered with confidence. The relationship between stratigraphic misfit and elastic thickness shows that usually an upper limit, but not a lower limit, for elastic thickness can be retrieved. Our general approach is applicable to any extensional sedimentary basin, including highly extended passive margins, and it should be regarded as the stepping stone to more sophisticated two-dimensional and three-dimensional inverse modeling. In the companion paper, we apply our algorithm to a set of Phanerozoic extensional sedimentary basins located worldwide.

Published 26 October 2002.

Index Terms: 3260 Mathematical Geophysics: Inverse theory; 8105 Tectonophysics: Continental margins and sedimentary basins; 8109 Tectonophysics: Continental tectonics—extensional (0905); 8120 Tectonophysics: Dynamics of lithosphere and mantle—general.

Read Full Article (file size: 1553505 bytes)    Cited by

Citation: White, N., and P. Bellingham (2002), A two-dimensional inverse model for extensional sedimentary basins 1. Theory, J. Geophys. Res., 107(B10), 2259, doi:10.1029/2001JB000173.