FastFind »   Lastname: doi:10.1029/ Year: Advanced Search  

AGU: Journal of Geophysical Research, Planets

 

Keywords

  • aeolian processes
  • ventifacts
  • wind abrasion

Index Terms

  • Planetary Sciences: Solid Surface Planets: Surface materials and properties
  • Planetary Sciences: Solid Surface Planets: Erosion and weathering
  • Planetary Sciences: Solar System Objects: Mars
  • Atmospheric Processes: Boundary layer processes
Abstract
Cited By (3)
 

Abstract

JOURNAL OF GEOPHYSICAL RESEARCH, VOL. 110, E12004, 24 PP., 2005
doi:10.1029/2004JE002388

Trajectories and energy transfer of saltating particles onto rock surfaces: Application to abrasion and ventifact formation on Earth and Mars

Nathan T. Bridges

Jet Propulsion Laboratory, Pasadena, California, USA

James Phoreman

Department of Geological Sciences, Arizona State University at NASA-Ames Research Center, Moffett Field, California, USA

Bruce R. White

Department of Mechanical Engineering, University of California, Davis, Davis, California, USA

Ronald Greeley

Department of Geological Sciences, Arizona State University, Tempe, Arizona, USA

Eric E. Eddlemon

Department of Geological Sciences, Arizona State University at NASA-Ames Research Center, Moffett Field, California, USA

Gregory R. Wilson

Jet Propulsion Laboratory, Pasadena, California, USA

Christine J. Meyer

Department of Geological Sciences, Ohio University, Athens, Ohio, USA

The interaction between saltating sand grains and rock surfaces is assessed to gauge relative abrasion potential as a function of rock shape, wind speed, grain size, and planetary environment. Many kinetic energy height profiles for impacts exhibit a distinctive increase, or kink, a few centimeters above the surface, consistent with previous field, wind tunnel, and theoretical investigations. The height of the kink observed in natural and wind tunnel settings is greater than predictions by a factor of 2 or more, probably because of enhanced bouncing off hard ground surfaces. Rebounded grains increase the effective flux and relative kinetic energy for intermediate slope angles. Whether abrasion occurs, as opposed to simple grain impact with little or no mass lost from the rock, depends on whether the grain kinetic energy (E G ) exceeds a critical value (E C ), as well as the flux of grains with energies above E C . The magnitude of abrasion and the shape change of the rock over time depends on this flux and the value of E G > E C . Considering the potential range of particle sizes and wind speeds, the predicted kinetic energies of saltating sand hitting rocks overlap on Earth and Mars. However, when limited to the most likely grain sizes and threshold conditions, our results agree with previous work and show that kinetic energies are about an order of magnitude greater on Mars.

Received 17 December 2004; accepted 9 September 2005; published 7 December 2005.

Citation: Bridges, N. T., J. Phoreman, B. R. White, R. Greeley, E. E. Eddlemon, G. R. Wilson, and C. J. Meyer (2005), Trajectories and energy transfer of saltating particles onto rock surfaces: Application to abrasion and ventifact formation on Earth and Mars, J. Geophys. Res., 110, E12004, doi:10.1029/2004JE002388.

Cited By

Please wait one moment ...